Switch(config-cfs-region)# show cfs region brief When you create a region, the CLI places you into Region Configuration mode for that region, where you can then add an application. This example shows how to create region 4 and add the NTP application to it. If CFS distribution is disabled for an application, then that application does not distribute any configuration and it does not accept a distribution from other devices in the fabric. All devices in the fabric must have CFS enabled or they do not receive distributions. In order to distribute configuration information, CFS distribution must be enabled for both the device and the application.ĬFS is enabled by default for the device. If you attempt to add an application to the same region more than once, the following message appears:Īpplication already present in the same region. If you remove an application from a region, and do not assign it into a different region, then it is added to the default region, region 0. Once you assign an application to a CFS region, its configuration cannot be distributed within another CFS region.
However, on a given device, only one CFS region at a time can distribute the configuration for a given application. You can set up a CFS region to distribute configurations for multiple applications. If a feature is moved, that is, assigned to a new region, its scope is restricted to that region it ignores all other regions for distribution or merging purposes. To send a Call Home message to all configured destinations, use the callhome send command. Sends the specified Call Home test message to all configured destinations.
Sends a test message to all configured destinations.Ĭallhome send Specifies the priority number for this device.Ĭreates and configures a Call Home destination profile.Įnables Call Home.
Specifies the site ID number for this device. Specifies the service agreement customer number for this device. Specifies the service agreement contract number for this device. Specifies the street address of the person responsible for the device. Specifies the phone number of the person responsible for the device. Specifies the e-mail address of the person responsible for the device. Specifies or modifies the snmp-server contact name for Call Home. This command has no arguments or keywords. To enter the CLI Call Home configuration mode, use the callhome command. This chapter describes the Cisco NX-OS system management commands that begin with the letter C.
0 kommentar(er)
